Recent content by luisazmz

I noticed the intake cam chain (part #6) tightens and loosens when I manually turn the engine over. I'm aware that chains have tight spots but when this loosens up it's hits the chain guide that goes overtop (part #14). If I adjust the cam chain tensioner once the engine is idling (part #11)...

It does seem like to it me as well, but that’s as for as they'll close. Any suggestion as to why they’re not closing fully?

I used two bits of the same size, one placed on carb #2 and then synced 1,3 & 4 so they would be opened the same amount. Hopefully that makes sense. I was sure that they all covered the furthest hole of the two holes in the middle of the carb. I can’t get them to close more. The photos show how...

I took the carbs off the bike to bench sync them, put them back on and now the bike is starting up at 5,000 rpm + and it won’t go down, choke is off. I was afraid of letting it run cold on such high rev, max time was 30 seconds and it won't go done. When I killed the engine some type of...