Loki

When you changed the right hand switch gear did you interfere with anything else? With the key in the ign position you say all the...

There's a few out there Frosts have an Eastwood product which should be enough for 2 oil changes and not that expensive but before going...

I have a fork leg which was supplied to me as an F1 leg but it isn't, seller isn't replying to messages so need to find out what it is...

Whilst I agree with most of the previous comments, and by the way I use VR-1 in both of my Chevys, the info all refers to CAR...

Does yours have the ribbed hub? that seems to be the F1 type and I have the K type which fits fine so I think I'll leave it as is as...

Got stuck into the dents in my tank today, tried a glue puller kit a few weeks back but the glue wasn't strong enough to pull them out...

Has the damper valve failed on the gauge? Loki

That looks very much like my F1 front wheel, can't be sure as your attachment doesn't open any more? Loki

My earth came into the headlight with a 4 way connector then from there to the various points in the headlight needing earths but still...

Indicators sorted, it was a bad earth, just got to figure out how to get it good! Loki

Had a Eureka moment after a morning of gardening in the blazing sun, ran a direct earth from the battery negative to the indicator light...

Having a gardening day today to get my head straight before I go back to the electrical gremlins. Loki

Sat down with the wiring diagram last night then drew out the indicator circuit in isolation and the only common denominator I could see...

I have had my electrical hat on today, lights seem OK now, checked brake light all good apart from the front brake light switch which...

Further update with electrics, after adding 2 temporary rear indicators they worked left and right but only the rear ones and they...

Meant to say I fitted the front indicators last thing before I packed up and when switch left or right both repeaters come on but...

Had a better day today, solved a couple of issues with the loom, one of my making and another from the PO some strange wiring to the...

New ones all Chinese and re chrome was more or less same price so that’s why. Same with the mudguard same price re chrome or Chinese and...

Further progress today, finally got a set of F1 forks fitted to my bike, has been a long drawn out process after sending my original...

Looks very much like the kit I just had from China but mine had the float pivot pins, princely sum of £17.15 post free from China! not...

Rear brake all together now filled with fluid and bled, dropped off my chroming but quoted 10 weeks turnaround so will be stuck to make...

Take a look at page 170 in the shop manual downloadable from this site for the diagram of the route. Loki

I had one with slightly less damaged but managed to dress it back into shape with a small hammer, go gently a little at a time, might...

$50? he must have seen you coming lol Loki

At least if I go that route I'll have a pair of refurbished K7/K8 fork legs to sell to offset the expense. Loki

These legs are hard chromed, very different to decorative chrome plating, I worked offshore with Itallian built hydraulic cranes and...

Found these https://www.wrs.it/en/fork-tubes/194324-tnk-fork-tube-standard-chromed-honda-cb-750-f1-super-sport-750-1976.html just over...

BTW I have fitted K7/K8 fork legs to my yokes just so I can move the bike around, I think the legs are 620mm, does put the front a bit...

CB750A (automatic) also has 35 x 585 mm legs but I don't have details of the oil locks. I had also wondered about shortening readily...