brettp

Not sure how you installed it but did you leave everything loose and then tighten down after everything was set up? I would also check...

Going up a 16th of an inch will have almost zero impact.

If you have Mikunis, are they CR?

I don't have your generation of bike, but if you're not getting spark on 1and 4 but the points are good, it is time to dive into testing...

Absolutely, if the dimensions are good. I tried with fiberglass. Might try again.

Funny you mention it. I looked into that. That voltmeter is the smallest I could find; .25". The housing for the voltmeter is too big...

Added a voltmeter today. Well, finished it after 2 weeks, anyway. Built it out of sheet metal, soldering the seams. Instrument...

Been there. Seattle is dicked up, anyway. Better off driving across the mountains for a good deal.

You're right, that is too expensive for that bike

It's all over the forum. So many people have tried.

Used a screwdriver many times to pinpoint stuff like that. The vibrations run through metal really because the metal's molecules are...