Azdevil09

Haha yea it’s quite the pickle for sure. I just started welding but I think I may just take this one to the shop to be safe.

Haha,,,, well I went ahead and drill a small hole into the bolt and they used one of those “remove a screw” bits. That grabbed but just...

Doing my first ever engine rebuild, learning along the way. I am currently Re-assembling my 81 750 engine and I have had my first...

Couple pictures to help.

Putting my crankcase back together and what are some watch outs for common forgotten items. Ie I keep hearing mention of the two...

Doing my first engine rebuild and while I was tearing down the motor, working on getting the crankcases separated (I think) I had the...

I can’t find a gasket kit as it seems they has been discontinued now. Can they still be had? Any suggestions on quality aftermarket?

Thank man.

So even with the micrometer, that will tell me OD of the main shaft but without knowing the case codes can I even get to a suggested...

Just inspecting and saw this. Not sure if this is a crack. Nothing is visible from the inside of the case. So not sure what’s going on...

Yea came to that conclusion as well. Plus I love tools even if I may never use again.looking around OfferUp now.

RC01E-2214692

looking for my journal markings. On the upper case I am seeing the below. Everything I read and watch says these should be alpha...

Haha. Well there you go!!

Shopping on a rebuild now!

They are pretty clean. Wiped me down with a rag and breakcleaner before the pic. But I’ll reshoot a few more cause I agree they look a...

Tearing down my first engine and wanted to get some seasoned eyes on my main bearings. They look good to reuse? I am Picking up some...

Do you have help or hoists etc? Or you just flying solo and looking for the easiest one man job?

Rebuilding engine on my 81 750. I know I have seen posts on here from amc about the "hard/expensive" to get main bearings for the DOHC...

Hey all. Just picked up my first 81 750. Doing attempting an engine rebuild and was wondering where the best place to buy parts online...

JB Weld?

Hey all been lurking and reading a ton on here as of late. I’ll skip the long intro (another thread)and cut to it. Picked up an 81...