• Enter the April CB750 Supply gift certificate giveaway! It's easy... Click here, post something, and you're entered into the drawing!

Recent content by ajh1

  1. A

    Workmanship. Am i being picky? (BCR Designs/Benjies cafe racers warning)

    Not sure what bike you have but I just bought delkevic for my cb750fa and it’s top quality stainless 4-1 Also Marvin do 4 -2 and 4-1 in chrome
  2. A

    crack in lower crankcase

    1st time Ive had pan off. I think its just a casting inperfection and probably been there forever. Apparently other people have seen similar cracks. I'll just check it again when I next change the oil
  3. A

    crack in lower crankcase

    Hi So I thought I'd check the oil strainer as I have the engine out currently on my 80 cb750fa, lucky I did as someone had been quite handy with instant gasket:) But then I found this crack in the case. It looks like its only a surface crack in a non stressed part of the case. I wondered if...
  4. A

    noise on idle from left end of crank / starter drive / ignition advance

    bit late but if it helps anyone, noise turned out the starter clutch bolts were all loose -
  5. A

    noise on idle from left end of crank / starter drive / ignition advance

    im going to take the case off and have a good look in a couple of weeks so will let you know if I find anything.
  6. A

    noise on idle from left end of crank / starter drive / ignition advance

    Hi, my first CB750F has been going well, I have it up and running with brakes so decided to put a few miles on it before I strip it down for painting. Ive got a blowing exhaust which doesnt help but can anyone help me diagnosing a rattle I have coming from the left side around the end of the...
  7. A

    Oh crud - rear brake master cylinder is toast. Ideas on replacement?

    Mine was scrap, too far gone to rebuild so I bought a cheap Chinese M/C whilst I investigate a factory Honda replacement. However, this one so far works well and I know others have also used it - https://www.ebay.co.uk/itm/184559576524.
  8. A

    Oh crud - rear brake master cylinder is toast. Ideas on replacement?

    anyone help with options for cb750f dohc rear master cylinder replacement?
  9. A

    First CB750, Frame question, Can you ID this?

    im new to cb750s too but coincidently came across this article which talks about a similar frame mod - https://oilysmudges.com/blog/honda-cb750f-freddie-spencer-replica/#.YheYPRPP2u4 I think its a fast Freddie replica mod!
  10. A

    cb750 dohc Vin / Engine number Identification

    Thanks for the reply - A bit more info that might help someone else. I think my chassis is a Japanese bike. Based on using cmsnl.com who allow you to put a vin number in to search for parts. And they recognise RC04-101 as HONDA CB750F 1980 (A) JAPAN RC04-101. And I think Japs use KPH speedos...
  11. A

    cb750 dohc Vin / Engine number Identification

    Hi New guy about to buy a CB750F to restore, wonder if someone could help me identify a bike from its Vin Number. Its supposed to be a CB750F 1980 and has KPMH speedo so guessing European Vin number is RC04-10139xx (All the documents Ive found so far say cb750f numbers start from RC04-...
See more
Back
Top