Lyle Laun
CB750 New member
Hello:
New to this forum. I've got a 1980 750k that I've just done the carbs on and am looking to sync the carbs and set the air/fuel screws. My Clymer manual isn’t real clear in showing where to tie in my manometer fitting on each carb. I assume, I just pull out the screw on the cylinder body just in front of each carb? Can anyone confirm this and if you know the fitting size that would be great.
Regards
Lyle
New to this forum. I've got a 1980 750k that I've just done the carbs on and am looking to sync the carbs and set the air/fuel screws. My Clymer manual isn’t real clear in showing where to tie in my manometer fitting on each carb. I assume, I just pull out the screw on the cylinder body just in front of each carb? Can anyone confirm this and if you know the fitting size that would be great.
Regards
Lyle
