I hate brakes!
Well, they are pretty necessary when you are riding, but I hate working on them. Was able to pump one of the pistons from these GL1000 front calipers out with a front master. The other wouldn't budge. Had to put an 8mm grease fitting in the bleeder hole and pump it out with the grease gun. All cleaned now and pistons dressed, awaiting seals and reassembly. Will have to get a Chinabay special for the rear master because after two hours to get it off, the rear is trash.
Got the CB750F dash mounted with a little mountain engineering and the G1000 headlight ears installed. Also installed new bearings in the front wheel.
This week is paint the G1000 week because the weather is forecast to finally be right.
Well, they are pretty necessary when you are riding, but I hate working on them. Was able to pump one of the pistons from these GL1000 front calipers out with a front master. The other wouldn't budge. Had to put an 8mm grease fitting in the bleeder hole and pump it out with the grease gun. All cleaned now and pistons dressed, awaiting seals and reassembly. Will have to get a Chinabay special for the rear master because after two hours to get it off, the rear is trash.
Got the CB750F dash mounted with a little mountain engineering and the G1000 headlight ears installed. Also installed new bearings in the front wheel.
This week is paint the G1000 week because the weather is forecast to finally be right.