Hello,
I am restoring this ‘74 CB750 SOHC, I knew the engine was running without any big issues so I put it back in the frame. It starts perfectly but after a while (when the engine is hot enough) it starts to leak some oil behind the ignition. I’m not sure if it’s the rubber O-ring or the gasket that’s leaking, I will upload an photo asap.
Any thoughs on how I should handle this issue?
Kind regards,
Brecht
I am restoring this ‘74 CB750 SOHC, I knew the engine was running without any big issues so I put it back in the frame. It starts perfectly but after a while (when the engine is hot enough) it starts to leak some oil behind the ignition. I’m not sure if it’s the rubber O-ring or the gasket that’s leaking, I will upload an photo asap.
Any thoughs on how I should handle this issue?
Kind regards,
Brecht
Last edited: