75SuperSport
CB750 New member
Recently my bike has been running like crap, breaking up on acceleration, poor idle, etc. I played around with several ideas then decided I needed to check out my coils. I discovered I had nothing on my 2&3 coil. I figured if I was going to replace one, I may as well replace both, so I ordered two new coils, condensers, plugs, boots, and points. I figured I would skip over the install on the points and condensers until after I got the bike running.I installed the new coils, lot of backfiring, which I never had before. After some quick looking around I noticed the wires on the new coils were reversed so I swapped the wires and the bike fired up. That was last night, today I came down to finish assembling the bike, it is only running on two cylinders, 1 & 4. After some attempts to get it running on all 4, now it doesn't run at all, no spark to the points. I installed the new points, nothing, installed the new condensers, nothing. I am at a complete loss as to why this is happening, anyone have any ideas?