Results 1 to 4 of 4
  1. #1
    CB750 Member nsxguy7's Avatar
    Join Date
    Feb 2015
    Location
    Fort Collins, CO
    Posts
    12

    SOHC timing....please help!!

    Hello all. I'm at wits end and hope someone can help me.
    75 SOHC motor. Just did a stock rebuild. Head professionally rebuilt. Everything lines up as per the manual. #1 cylinder at TDC, notch on the cam pointing up, etc. I adjusted the valves on cylinder #1 no problem. According to the shop manual, you adjust the exhaust valve on #2 and the intake on #3 at the same time. No dice. On both cylinders, even with the adjustment screw backed all the way in, the rocker is sitting tight against the top of the valve stem. I've triple checked everything and I'm stumped. Please help.

  2. #2
    Moderator dirtdigger's Avatar
    Join Date
    Feb 2012
    Location
    Black Hawk SD
    Posts
    2,610
    Remember cylinder 1 is on the left as you sit on the bike...lot of people get that mixed up. If you turn to tdc on cylinder 2 are the rockers loose? You can easily just adjust the valves one cylinder at a time, just put each on top dead center. On my high performance motors I do each lobe one at a time, turn it so each lobe is on the base circle of the cam.

  3. #3
    CB750 Member nsxguy7's Avatar
    Join Date
    Feb 2015
    Location
    Fort Collins, CO
    Posts
    12
    Thanks Digger. I knew you would chime in at some point. Yes, at least I got cylinder #1 right. I kind of finally figured out what you are saying. So if the notch on the end of the camshaft is at 12 o'clock when cylinder 1 is at TDC, is it at 3 o'clock when #2 is at TDC, 6 o'clock for #3, and so on? Thanks!

  4. #4
    Moderator dirtdigger's Avatar
    Join Date
    Feb 2012
    Location
    Black Hawk SD
    Posts
    2,610
    Just watch the timing mark on the crank. Turn to tdc number 1 set valves, turn half turn to tdc number 2 set valves, turn half turn to tdc 4 etc

Similar Threads

  1. Valve timing marks
    By Hillbilly Bike in forum Engine / Exhaust
    Replies: 4
    Last Post: 12-12-2017, 04:16 AM
  2. Dyna S timing
    By Jarrett_Honda in forum Electrical
    Replies: 3
    Last Post: 04-10-2017, 09:47 PM
  3. Timing adjustment out of limit
    By SeattleRod in forum Electrical
    Replies: 2
    Last Post: 08-16-2016, 10:23 AM
  4. I Had to cut my timing chain! What should I do now?
    By Kylelm in forum The CB750 Garage
    Replies: 13
    Last Post: 10-19-2014, 05:12 AM
  5. timing
    By willemsmathias in forum Engine / Exhaust
    Replies: 1
    Last Post: 08-08-2014, 07:46 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •