Results 1 to 3 of 3

Thread: Ign. fault

  1. #1
    CB750 Member chuter's Avatar
    Join Date
    Jul 2017
    Location
    usa
    Posts
    6

    Ign. fault

    Spent most of the late winter an early spring putting my F back together.
    I finally got a chance to ride and found that after about 20 min. running time 2 and 3 would cut out, after a few min. running on 1 and 4 it would kick back in and run good for quite a while sometimes and other times it would only run for a short time and quit again.. I went through all the wiring and cleaned all connections. Nothing bad stood out as obvious. After taking a chance I ordered another Dyna ign. system. Installed it and set it up and timed and wow. It runs like a bear now. Put about 100 miles on her and not a problem at all. I only have about 1000 miles on the Dyna system that failed and I am running their coils. Is this a common failure and am I going to repeat this problem in the near future? Just asking, chuter

  2. #2
    Moderator dirtdigger's Avatar
    Join Date
    Feb 2012
    Location
    Black Hawk SD
    Posts
    2,650
    Certain part number spread did go bad, but that was many years ago.

  3. #3
    CB750 Member chuter's Avatar
    Join Date
    Jul 2017
    Location
    usa
    Posts
    6
    Got another chance for a little putt last night, put about 70 miles on the odometer and bike has never ran this good. Always starts and runs well. I have put many hours in this build along with many bucks but I like what I have. Thanks to all for the help and valued information. RIDE SAFE. Chuter

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •