Results 1 to 3 of 3
  1. #1
    CB750 Member SkullDanny's Avatar
    Join Date
    Jul 2016
    Location
    Oldham England
    Posts
    6

    Micro switches and relays

    Hi gang.

    I want to remove the switch blocks on my 76 cb750k and replace with micro switches for a more discreet look.

    With the switches being very small I've heard it would be wise to use relays. But I cannot figure out the wiring. Would both the starter button and the kill/run switch require relays.

    I am aware the horn and flasher swiches will but again I don't understand the wiring.

    Can anyone explain it or have any wiring diagrams.

    The high low switch will be a higher amp switch on the headlight.

    D

  2. #2
    CB750 newb, XS650 finatic grepper's Avatar
    Join Date
    Oct 2012
    Location
    Lowell, MI
    Posts
    391
    Here's a graphic I keep hung up near the desk I use for wiring.
    Click image for larger version. 

Name:	Relays_zps8d484d9e.JPG 
Views:	8 
Size:	29.8 KB 
ID:	8027
    When you are worried about voltage drop over switches and want to put a relay in place it's important to know if you are switching - or +. ie. most neutral light switches switch negative/ground(-), while something like your head light switches positive (+) off the battery. The picture above is of a standard automotive relay, they are pretty cheap at any auto parts store or even cheaper off eBay. If your picky you can get bosch barnd for better quality. Follow the picture and a little bit of voltage can send full voltage to any component.
    Something I've been putting off till winter is putting a relay across the key switch on my 75 cb750.
    Drive fast and take chances

  3. #3
    CB750 Guru amc49's Avatar
    Join Date
    Sep 2015
    Location
    Fort Worth TX.
    Posts
    1,915
    The amp rating of the switch determines the need for a relay or not.

    Bear in mind most microswitches are NOT waterproof, almost a necessity on a bike.................in many cases the actual metal parts in the OEM switches are remoted to a certain small extent by plastic dividers and the mounting method and construction in the housing and such to not get water inside easily.

Similar Threads

  1. Handlebar switches
    By s10hornet in forum The CB750 Garage
    Replies: 1
    Last Post: 06-08-2014, 02:43 PM
  2. Ignition switch and Handle bar switches.
    By Flandango in forum Electrical
    Replies: 3
    Last Post: 01-15-2014, 04:52 AM
  3. Question on adding fuel injection (micro squirt)
    By wa-chiss in forum Carburetors / Fuel
    Replies: 2
    Last Post: 10-03-2013, 10:14 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •