Any information would be appreciated, I took the swing arm off yesterday and found that I have play in my bolt through the swing arm. After cleaning it up and looking it over the place where it rides in the bushings I believe is worn on one side on both ends where it should be a tolerance fit. The largest part of the machined bolt is 14.16mm and one side it only measures 13.7mm The rest of the bolt is 14.0mm My rear fork pivot bolt is worn and would like to replace it with a new or good one. Does any one sell a replacement bolt? Im sure if I buy one from ebay it will most likely be worn also. Probably not many sellers are looking at it to see its worn only if the chrome is good.