Hello fellow CB750 owners, I am a FNG in this forum, I recently purchased a used 1995 Nighthawk that I wanted to convert into a cafe racer.
Issues that Im having are carburetor, having install Pods, replacing the factory airbox, installed a Radiant Shorty slip on, exhaust, I purchased a 6 SIGMA DYNOJET KIT 1-3. After the install i have been having bogging issues at 3,000 RPM. Ive checked for vacuum leaks,etc. I was told that Intake PODS are the issue, TOO much air and not enough fuel. jet kit came with pilot jet and Primary, no needles, kit included 112, 115 and 117, currently 112 and 115 are installed, I tried the 117 but some reason mad it worse.
I not sure where to go from here, I was thinking it may be the exhaust with no backpressure...Anyways, if anyone has had a similar problem, I can use the help.
Issues that Im having are carburetor, having install Pods, replacing the factory airbox, installed a Radiant Shorty slip on, exhaust, I purchased a 6 SIGMA DYNOJET KIT 1-3. After the install i have been having bogging issues at 3,000 RPM. Ive checked for vacuum leaks,etc. I was told that Intake PODS are the issue, TOO much air and not enough fuel. jet kit came with pilot jet and Primary, no needles, kit included 112, 115 and 117, currently 112 and 115 are installed, I tried the 117 but some reason mad it worse.
I not sure where to go from here, I was thinking it may be the exhaust with no backpressure...Anyways, if anyone has had a similar problem, I can use the help.