Gentlemen,
disregard my earlier post about my clutch and trans. I was confused and asked the wrong questions.
Now I have another question and will try to ask it correctly with the proper terminology.
My bike came with PODS and stock 4 into 1 exhaust and the previous owner had put 122 mains, 42 slows, and floats at 22mm.
Needle is at center position.
My question.....is the reason the floats are set to 22mm rather than 26mm to accommodate the larger jets?
Everything I read says 26mm.
I have the carbs apart and will wait for advice before reassembly.
thanks in advance.
disregard my earlier post about my clutch and trans. I was confused and asked the wrong questions.
Now I have another question and will try to ask it correctly with the proper terminology.
My bike came with PODS and stock 4 into 1 exhaust and the previous owner had put 122 mains, 42 slows, and floats at 22mm.
Needle is at center position.
My question.....is the reason the floats are set to 22mm rather than 26mm to accommodate the larger jets?
Everything I read says 26mm.
I have the carbs apart and will wait for advice before reassembly.
thanks in advance.
Last edited: