I am in the process of doing a complete head-to-toe tune up of a good mate's Bitza CB750 (let's just call it a 1977K model), and he's been very good about ordering the parts I request, as I need them.
After getting the bike running again, and having a chance to give it a good shakedown run, I noticed a lot of dive in the front end, and upon tearing into the tubes, I noticed the bike still had its original springs, and asked that he order Progressive springs.
He bought them (new) from some supply warehouse, and there are no directions in the box. None at all.
The springs are a tad bit shorter than the stock springs, and have nylon spacers and washers included in the kit.
My questions are these:
What order are these bits to be installed in, and do I install the tight side of the coils face down or up?
Thank you all.
After getting the bike running again, and having a chance to give it a good shakedown run, I noticed a lot of dive in the front end, and upon tearing into the tubes, I noticed the bike still had its original springs, and asked that he order Progressive springs.
He bought them (new) from some supply warehouse, and there are no directions in the box. None at all.
The springs are a tad bit shorter than the stock springs, and have nylon spacers and washers included in the kit.
My questions are these:
What order are these bits to be installed in, and do I install the tight side of the coils face down or up?
Thank you all.