Search:

Type: Posts; User: Chrisraven

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    311

    Hi there amc49: Thanks for the input, just...

    Hi there amc49: Thanks for the input, just managed to get the carbs off and the number one slide is stuck solid so that is where the problem lies I believe. Will know more after I have done the...
  2. Replies
    11
    Views
    311

    Ok thanks for the input

    Ok thanks for the input
  3. Replies
    11
    Views
    311

    Do you think I should do a leak down test to...

    Do you think I should do a leak down test to verify everything inside the cylinder? Just trying to find out what might be causing the roughness on the running of the engine. While it seems to idle...
  4. Replies
    11
    Views
    311

    Hi amc49: Just wanted to ask you about the...

    Hi amc49: Just wanted to ask you about the compression in my 1980 750C. I have 150 on number one and 145 on the other three. Is this an ok pressure, I was reading in the manuals and they were...
  5. Replies
    4
    Views
    108

    Hi amc49: Would you know anyone that rebuilds...

    Hi amc49: Would you know anyone that rebuilds these carbs by chance?
    Thanks
  6. Replies
    4
    Views
    108

    Thanks amc49, I joined the other site and left a...

    Thanks amc49, I joined the other site and left a message for Fitz. Now will see if he responds.
    I started the bike up again today and now it idles about 900 to 1000 without dying. Perhaps it just...
  7. Hey Blackmax88 send me your email and I will...

    Hey Blackmax88 send me your email and I will upload the shop manual for your bike.
    Thanks
    Chris
  8. Replies
    4
    Views
    108

    Looking for Fitz

    Hi there: I was talking with Sean who used to clean carbs and he says he doe not do that anymore and recommended a person here on the site named "FITZ", I have not been able to locate him. Anyone...
  9. Replies
    3
    Views
    84

    I just made the assumption that the 750 had...

    I just made the assumption that the 750 had points in it, I had in 1976 a 76 750 Four. Nothing in the 750 line since. Have had a few Goldwings and the only one I had to work on was a 1977 GL1000...
  10. Replies
    19
    Views
    6,800

    One could look into the new 3D printing that they...

    One could look into the new 3D printing that they claim can be done with metal, just for Texas maybe? lol I have found if one constructs the tabs or repairs with the same type of plastic (very...
  11. Replies
    3
    Views
    84

    Carb Rebuild? or ?

    I just got a 1980 750 Custom. A good barn find actually; if has been sitting for the better part of 32 years. This was a really "pig in a poke" gamble for me. When I looked at it, all the parts...
  12. Replies
    19
    Views
    6,800

    It is actually much easier to just build up the...

    It is actually much easier to just build up the plastic with new molden plastic with a plastic welder and then shape the material with a dremel, then paint it and no one will even know you had a...
  13. Replies
    19
    Views
    6,800

    I would suggest you hot weld new plastic on the...

    I would suggest you hot weld new plastic on the covers and then shape them with a dremel tool. Should work just fine, plus the plastic welder is not that expensive. I have rebuilt many fairings and...
Results 1 to 13 of 13