Search:

Type: Posts; User: Wez_

Page 1 of 13 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    67
    Views
    7,101

    Looking really nice !! Keep up the good work!!...

    Looking really nice !! Keep up the good work!! :thumbsup:
  2. Thread: 1982 CB 750 K

    by Wez_
    Replies
    3
    Views
    262

    Hello from Connecticut! I actually work in...

    Hello from Connecticut! I actually work in Ellington, CT. Go figure. Anyways, you missed the swap meet in Stafford Springs this past weekend. Other than that, score a stock air box off ebay and...
  3. Replies
    2
    Views
    265

    Just remove the grip and switch and add maybe a...

    Just remove the grip and switch and add maybe a 1" wide, single layer thickness of Gorilla glue tape onto the handle bar. That stuff sticks amazingly. Then snug the switch down onto the slightly...
  4. try 4into1.com They usually have everything. ...

    try 4into1.com They usually have everything. Try their Ebay store. If you don't like the way it's setup. Try their online website.
  5. Replies
    1
    Views
    144

    She's looking nice

    She's looking nice
  6. Replies
    6
    Views
    462

    It's usually the piston rings that are the...

    It's usually the piston rings that are the problem.

    Also. make sure you have a full battery, warm conditions and test each cylinder one at a time. Also, you must be WOT (wide open throttle) while...
  7. Replies
    6
    Views
    462

    So it cranks, but wont start correct? Does it...

    So it cranks, but wont start correct? Does it show any signs of ignition while cranking? Sort of sounds like the valves are not doing what they are supposed to be doing. Maybe trapping the un...
  8. Replies
    3
    Views
    326

    pretty sure I went with 4into1.com for that part

    pretty sure I went with 4into1.com for that part
  9. Replies
    1
    Views
    392

    Try this link: ...

    Try this link:

    https://bikebrewers.com/motogadget-m-unit-wiring/
  10. :thumbsup:

    :thumbsup:
  11. This sounds like the third restoration that...

    This sounds like the third restoration that needed to burn off some extra carbon from the combustion chambers and or replace the spark plugs. Perhaps the plugs are fouled out. Were the heads opened...
  12. Nice work pidjones! That's the typical path to...

    Nice work pidjones! That's the typical path to success. Get it running, tires, brakes and electrical finishing touches. Should be a nice ride at this rate. Keep up the good work!
  13. Replies
    2
    Views
    589

    The forks don't just slide in the triple tree? I...

    The forks don't just slide in the triple tree? I was able to loosen the 4 bolts from the lower and upper triple trees and the front of the suspension lowered. Tighten the triple tree mounting bolts...
  14. black with carbon deposit or black from oil?

    black with carbon deposit or black from oil?
  15. Replies
    3
    Views
    335

    Great. We are here for you!

    Great. We are here for you!
  16. Replies
    3
    Views
    404

    use what you need: 8802 8803 8804 8805

    use what you need:

    8802

    8803

    8804

    8805
  17. Replies
    3
    Views
    404

    In the Clymers manual it tells you how to measure...

    In the Clymers manual it tells you how to measure the resistance across the regulator/rectifier pins. I had charging problems and thought it was my rectifier. Turns out after measuring the...
  18. Thread: Engine removal.

    by Wez_
    Replies
    6
    Views
    508

    My 82 CB750SC does have the removable frame...

    My 82 CB750SC does have the removable frame section.
  19. Who knows. They could have sprayed starter fluid...

    Who knows. They could have sprayed starter fluid in the carbs to get it to run for you. Lets assume it did run even though that's surprising for half disconnected carburetors. Then the compression...
  20. Thread: Engine removal.

    by Wez_
    Replies
    6
    Views
    508

    I had the engine out twice both times I wiggled...

    I had the engine out twice both times I wiggled it out from the right side as suggested in the manual. Perhaps I will try the lay down method at some point, but what about reinstallation? I try to...
  21. Replies
    3
    Views
    335

    I've been working on my custom build of a CB750...

    I've been working on my custom build of a CB750 KZ (which has an 1980 FA Engine) for a few months now.

    What does the above statement really mean? What was it's original condition and "work" have...
  22. Sexy looking bike. So what's the background? ...

    Sexy looking bike. So what's the background? Did you or someone else rebuild the motor? Was it previously running before the overhaul? It looks pretty clean. The PODS will not effect start up. ...
  23. Replies
    3
    Views
    385

    If you need to bump up the idle to further...

    If you need to bump up the idle to further troubleshoot the bike, reach under the carbs directly in the center and adjust the black knob that imaged below. adjust it clockwise for more idle .
    8781
  24. Replies
    17
    Views
    1,073

    Just get a new tank and don't ever use that...

    Just get a new tank and don't ever use that sealer. Take your time and shop eBay until you find a clean tank. Once it's regularly filled with gas, you will be fine. Why risk contaminating your...
  25. Replies
    3
    Views
    332

    Very slick. Two thumbs up!!

    Very slick. Two thumbs up!!
Results 1 to 25 of 318
Page 1 of 13 1 2 3 4