Search:

Type: Posts; User: madmtnmotors

Page 1 of 11 1 2 3 4

Search: Search took 0.02 seconds.

  1. Always needing parts!

    Always needing parts!
  2. Some good "How-To" info here: ...

    Some good "How-To" info here:

    http://forums.sohc4.net/index.php?topic=146893.0
  3. Replies
    5
    Views
    454

    This guy is making new ones that help overcome...

    This guy is making new ones that help overcome the inherent weakness of the original parts tendency to break:

    http://forums.sohc4.net/index.php/topic,166504.0.html
  4. Pick me! Pick me! :pimp:

    Pick me! Pick me! :pimp:
  5. Woo-hoo! Free parts are good! :cool:

    Woo-hoo! Free parts are good! :cool:
  6. Pick me!

    Pick me!
  7. Free parts are good!

    Free parts are good!
  8. Count me in!

    Count me in!
  9. Replies
    2
    Views
    1,631

    http://www.hondachopper.com/garage/simple_wiring_d...

    http://www.hondachopper.com/garage/simple_wiring_diagram/simple_wiring_diagram.html
  10. Thread: Shoppes

    by madmtnmotors
    Replies
    2
    Views
    793

    Mike Rieck, JMR Porting is an artist. High...

    Mike Rieck, JMR Porting is an artist. High quality = $$$
  11. I'm in again!

    I'm in again!
  12. Replies
    3
    Views
    582

    On the 77/78 A/K/F CB750's the connection at the...

    On the 77/78 A/K/F CB750's the connection at the rear of the crankcase goes to the bottom of the oil tank. The connection at the valve cover (in stock trim) was connected to a vapor separator under...
  13. I tend to favor mineral oil as well. It also...

    I tend to favor mineral oil as well. It also seems to smooth out the operation of the transmission and transmission clutch too.
  14. Mine has been doing this (sporadically) for more...

    Mine has been doing this (sporadically) for more than 20,000 miles. Over 50,000 miles on it now and it doesn't seem to be getting any worse. Once it slips I just let off the starter button and try...
  15. I'm in! Pick me! Pick me! :wink2:

    I'm in! Pick me! Pick me! :wink2:
  16. Replies
    5
    Views
    932

    I think this was resolved on another forum. He...

    I think this was resolved on another forum. He had dislodged one of the throttle cables or choke cable IIRC
  17. Replies
    4
    Views
    1,036

    A.P.E. in California, but I'm not sure if they...

    A.P.E. in California, but I'm not sure if they will do the entire engine. Might be worth asking:

    http://cbrzone.com/sohc.html


    Hondaman in Colorado wrote the book on these old CB750's:
    ...
  18. Parts are good, always needing parts!

    Parts are good, always needing parts!
  19. Did you turn the fuel valve off after you got it...

    Did you turn the fuel valve off after you got it home (best practice in case the carbs start to leak) and then forget to turn the fuel valve back on? Sounds silly, but I have done it!

    If it ran...
  20. You can still get bulk 3.5mm tubing of the...

    You can still get bulk 3.5mm tubing of the correct size directly from Honda. It's a little pricey but I like the way the stock tubing fits properly:
    ...
  21. Yes, they are required. Save these and place them...

    Yes, they are required. Save these and place them inside the new crossover rubber hose. They are NLA from Honda, but new ones can be fabricated from simple metal tubing of proper inner and outer...
  22. What part of Florida are you located?

    What part of Florida are you located?
  23. Parts are good, free parts are even better!

    Parts are good, free parts are even better!
  24. Parts are good!

    Parts are good!
  25. Parts are good...:)

    Parts are good...:)
Results 1 to 25 of 273
Page 1 of 11 1 2 3 4