Search:

Type: Posts; User: amc49

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Maybe. Watch the opposite side where sprocket hub...

    Maybe. Watch the opposite side where sprocket hub fits into the rubber absorbers, some have 4 tabs and some have 5. Both are drums.
  2. Replies
    1
    Views
    13

    I always ran 8 plugs and a is virtually the same...

    I always ran 8 plugs and a is virtually the same as s. I ran non-r plugs to use the resistance at the gap instead by opening gap a bit.

    When you block the aircuts you block off like one half the...
  3. Replies
    3
    Views
    44

    Yes, the US spec 750 in '84 was a 700. Be VERY...

    Yes, the US spec 750 in '84 was a 700. Be VERY careful, the '83 and earlier 750SC is NOT the same engine as the Euro 750SC in '84 was. No parts interchange there.
  4. Replies
    6
    Views
    48

    If the battery jumper cables are too small like...

    If the battery jumper cables are too small like so many now it will not jump, you got volt but no amp due to crap cables.
  5. Replies
    2
    Views
    34

    If the aesthetics of the crap looking part bother...

    If the aesthetics of the crap looking part bother you I have ground say opposite side to match a cleaned up one to make a custom looking one off cylinder block that can look acceptable. As long as...
  6. You're probably right..........thinking of the...

    You're probably right..........thinking of the later bigger bikes.

    Regardless, no reason you can't do it yourself.

    The only thing I would beware of was trying to re-insert the fork tubes back...
  7. 38s are too big for a 750 unless fully ported...

    38s are too big for a 750 unless fully ported head and wild cams in my view, more like 1100 carbs. The aftermarket carbs if chosen right will make about 10+ hp right off the bat as they are direct...
  8. You do not have to let the dealer take the forks...

    You do not have to let the dealer take the forks apart. The only reason they say so is because of the TRAC assembly used for anti-dive on them, people don't understand them. Trying to scare people...
  9. Replies
    2
    Views
    54

    Best thing I could say would be 75-115 on pod...

    Best thing I could say would be 75-115 on pod jetting and the exhaust must WORK rather than just being cosmetic and the engine must be well sealed too to draw correctly on the CVs with pods. CVs work...
  10. Thread: High rpm cutout

    by amc49
    Replies
    3
    Views
    90

    You are talking death with the valve opinion you...

    You are talking death with the valve opinion you have there. Without a compression test you have zero idea of how the valves are, these burn them much easier than others as they do the opposite of...
  11. Thread: New Member

    by amc49
    Replies
    1
    Views
    57

    Use the alt rotor nut under right hand cover of...

    Use the alt rotor nut under right hand cover of engine, NOT the one on the left! (as sitting on bike) Turn CLOCKWISE ONLY.

    Headlights will come on and brakelight too if brake pedal pushed. You of...
  12. Thread: High rpm cutout

    by amc49
    Replies
    3
    Views
    90

    Set your valves first, nobody ever does it and...

    Set your valves first, nobody ever does it and the single biggest cause of them not revving fully out without missing. Number two reason will be pods if somebody has put them on and then after that...
  13. Replies
    4
    Views
    132

    It hovers and must wobble a bit, it allows the...

    It hovers and must wobble a bit, it allows the flow to center it. Positive solid contact would lead to lightning wear.

    Need Keihin brand jets, after market often do not flow right and will not be...
  14. Replies
    4
    Views
    132

    Sounds like completely wrong parts set. Pilot...

    Sounds like completely wrong parts set. Pilot will NOT work.
  15. Without knowing the exact fuel amount in a 400...

    Without knowing the exact fuel amount in a 400 tank I'd bet a million the 750 tank is bigger at 5.3 gallons.

    (edit) Just found it, the CB400N, the T model is different style. The N has 3.7 gallon...
  16. Replies
    1
    Views
    146

    You are not going to find any dimensions on a...

    You are not going to find any dimensions on a brake pedal as they pretty much work only on the model they were designed to, they pretty much never swap to other models. One MIGHT luck out but no way...
  17. Replies
    1
    Views
    123

    For Sale - You need the model, every one is different there.

    You need the model, every one is different there.
  18. Should work fine if you jet up the main jet only...

    Should work fine if you jet up the main jet only maybe by 10 higher than OEM, provided the header is one that 'works'. Use the OEM paper or whatever filter comes in the box, they can even be...
  19. They go rich with the pods, it causes them to...

    They go rich with the pods, it causes them to open slides slower and later making engine richer. Then people think you have to 'jet up' for the pods making it even worse.

    If your plugs are black...
  20. Replies
    2
    Views
    165

    Just so you know, it shares nothing at all with...

    Just so you know, it shares nothing at all with the '83 and earlier original Nighthawk based on the 1st gen DOHC. You would be looking at Nighthawk in that '84 year.
    ...
  21. Replies
    1
    Views
    96

    750F tanks of the same year are the same as 900....

    750F tanks of the same year are the same as 900. US 1100F are too but be aware of fuel tap size changes. Petcocks got bigger as the years went on, IIRC 3 different sizes used there. Basic F tank is...
  22. Thread: Master Cylinder

    by amc49
    Replies
    25
    Views
    955

    The 425 number is 750 and model, it's part of the...

    The 425 number is 750 and model, it's part of the complete part number. '425' means DOHC 750. 73(0) is the last digits in part number meaning C model. The other number is likely numerical as in seats...
  23. Thread: Master Cylinder

    by amc49
    Replies
    25
    Views
    955

    Read the link--it shows the paint code sticker...

    Read the link--it shows the paint code sticker which is not either number stamped there. The paint code list clearly shows candy muse red as code R-104C-U.
  24. Thread: Master Cylinder

    by amc49
    Replies
    25
    Views
    955

    https://www.motorcyclespareparts.eu/en/honda-parts...

    https://www.motorcyclespareparts.eu/en/honda-parts/honda-color-codes
  25. Thread: Master Cylinder

    by amc49
    Replies
    25
    Views
    955

    https://www.cyclechaos.com/wiki/Honda_CB750C ...

    https://www.cyclechaos.com/wiki/Honda_CB750C

    Says 'Cosmo Metallic' black there. The one I drove was blue and may have been '81 as it had twin disc in front, '80 only had a single.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4