Search:

Type: Posts; User: amc49

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    3
    Views
    54

    Anytime. ...

    Anytime.

    https://www.walmart.com/ip/New-Silicon-Rectifier-Diode-For-Honda-31700-124-003-31700-124-008-S3H-02/721830017

    What it often looks like but may be buried under a lot of electrical wrap.
  2. Replies
    1
    Views
    44

    Still likely carbs clogged or down on...

    Still likely carbs clogged or down on compression, the engines do NOT rev cleanly with low compression. The choke on seeming to push right through may be choke removing part of your power to not show...
  3. Replies
    1
    Views
    53

    https://www.partsnmore.com/parts/honda/cb750k/?fil...

    https://www.partsnmore.com/parts/honda/cb750k/?filters[category]=accessories&filters[fitting]=custom&filters[year]=1971

    Decals somewhere on that page, other suppliers may have them too. The decals...
  4. Replies
    3
    Views
    54

    It's a one way power flow device that stops power...

    It's a one way power flow device that stops power from running backwards in a circuit that has two powered legs where one being active can flow power backwards through the one that is not powered....
  5. Replies
    4
    Views
    72

    A typical result and what gets people in trouble....

    A typical result and what gets people in trouble. Anything below 100 is a dead cylinder and it would indeed be odd to have all 4 the same number, well nigh impossible. Points at a crap gauge. I...
  6. Replies
    3
    Views
    64

    Use thinner oil. No oil is worse, the fork beats...

    Use thinner oil. No oil is worse, the fork beats itself to death with damaged parts. Less oil puts you closer to that. Earlier models do not necessarily have softer springs, they can be harder. Too...
  7. Replies
    3
    Views
    76

    I've seen needles swell out of shape in 24 hours,...

    I've seen needles swell out of shape in 24 hours, the wrong rubber there will not tolerate ethanol at all. Most people never grasp that even normal good fuel with no ethanol in it will swell rubber...
  8. Replies
    4
    Views
    72

    Run compression to make sure valves not burned,...

    Run compression to make sure valves not burned, they burn very quick if not kept set and were supposed to set at 600 miles, most never got it. Valves need to set at .005", they burn at .002" as it is...
  9. Replies
    3
    Views
    76

    New needle quality has been a huge problem with...

    New needle quality has been a huge problem with most carb kits and even more if your gas now has ethanol in it. The ethanol swells the rubber tip to not seal right. The Chinese parts do not often use...
  10. You are correct. The rear mounting bolt hole...

    You are correct. The rear mounting bolt hole location will be off due to the longer F bike aluminum plate extension, the K type (part of frame on that one) is shorter, there may be some slight...
  11. Replies
    10
    Views
    1,675

    I'd bet that 'kit' mentioned in post #6 does not...

    I'd bet that 'kit' mentioned in post #6 does not and never did exist, more like somebody rounding up a set of OEM parts. The only real reason to change them would be in case of bad seals to rust, the...
  12. Replies
    3
    Views
    156

    If you use ethanol in the local fuel, what it...

    If you use ethanol in the local fuel, what it does to the carbs. The sitting does the rest. Ethanol is pretty transparent until the devices quit getting used every day, then the damage starts. Check...
  13. Replies
    1
    Views
    105

    Looks like '79-'80 F bike fork to me. The lowers...

    Looks like '79-'80 F bike fork to me. The lowers were painted black like that too.
  14. Replies
    7
    Views
    255

    No, it isn't. It's for dual discs and why it's...

    No, it isn't. It's for dual discs and why it's 5/8". The original one is 9/16" as it was used on a single disc bike, and why your parts are too small.
  15. If the valve cover has never been off they can...

    If the valve cover has never been off they can seem to be glued on.

    Go here and register for free and then go to the technical documents section to get the OEM service manual in sections.......
    ...
  16. Man, in my book it matters not if it is a bike or...

    Man, in my book it matters not if it is a bike or car or battleship or atomic reactor. If one has the knack for mechanical then jump into it, just jump advised. You can think and nobody else has that...
  17. '...the bike was adjusted by the previous owner...

    '...the bike was adjusted by the previous owner to run with these air leaks...'

    It could only run worse. The more the air intake leaks back of carbs the less the slides open up and that is a sure...
  18. Well you need to fix the flood leak, ethanol...

    Well you need to fix the flood leak, ethanol likely causing it if they use it in your local fuel and common.

    Adjust the idle speed with the engine hot and then do what it takes to keep engine...
  19. See below, the machine double-posted on an...

    See below, the machine double-posted on an edit..........
  20. No to both questions. If you have the idle...

    No to both questions.

    If you have the idle speed sped up to hold engine at a stone cold idle with the throttle off, that is wrong, you set idle speed for hot engine only and suffer the cold...
  21. Never tear down after only one test, you need to...

    Never tear down after only one test, you need to read them all and multiple times (3-4 at the very least) as compression testing has so many errors that come with the process. If you were not holding...
  22. Looks like you are looking for N424-6-XX pilots...

    Looks like you are looking for N424-6-XX pilots or slow jets for Keihin. Need like 35 or 38 there, 40 is a bit too rich. Looks like they are drying up too, way harder to find them than it used to be....
  23. Replies
    1
    Views
    132

    Pics needed there, commonly can be up to lots of...

    Pics needed there, commonly can be up to lots of parts mismatched to make for questions as to exactly which year it is.

    The frame plate on steering head will tell you frame year if it is still...
  24. 'Sending people to the competition?' Is that...

    'Sending people to the competition?'

    Is that verboten? I send people to the C and F DOHC bike sites for manuals too, that could be considered the same thing..........lemme know if I am crossing a...
  25. Well, you know you can't run around with the...

    Well, you know you can't run around with the choke on full. Likely you have freed up some trash to stop carbs back up again, common if the tank was rusted, the ethanol can do it in as little as a...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4