• CB750.com is dedicated to the Honda CB750 SOHC and DOHC motorcycles and to their owners who love to ride, restore, and customize them.  All CB750 enthusiasts are welcome regardless of where you are from or whether you are into CB750 choppers, bobbers, cafe racers, drag bikes, or restorations.  Enjoy the site!
  • Thunder87m

    There is no available content written by Thunder87m
  • Recent Forum Posts

    1977F2

    Looking mostly for a tank, but considering any parts you folks might have available. Thanks.

    1977F parts

    1977F2 Yesterday, 06:13 AM Go to last post
    Matku

    Hello. Sadly sold my bike and never had the chance to fit those lovely forged pistons

    Price 460$ but ebay auction starting at $350. I think

    Wiseco Big Bore kit K823 DOHC

    Matku 11-24-2020, 08:34 AM Go to last post
    amc49

    Axle is long enough to hold it as a handle to keep rotor from striking the floor which will likely ruin it. Use like a 5 lb. baby sledge, I know it sounds

    Remove rotor to split crank case?

    amc49 11-23-2020, 07:35 PM Go to last post
    flatpick13

    Sorry, was reading this one my phone, just got what you were saying about pulling the rear axle from the rear wheel to use as a puller... thanks, thatís

    Remove rotor to split crank case?

    flatpick13 11-23-2020, 02:19 PM Go to last post
    flatpick13

    Ok, thanks amc49, I appreciate the advice! I already ordered a shorter pulled with a 19mm hex end instead of the axle, but I think I can make it work,

    Remove rotor to split crank case?

    flatpick13 11-23-2020, 02:01 PM Go to last post
    amc49

    The axle is better as you have a handle to hold the part when it suddenly springs off crank like they usually do. Whatever 'puller' you use gets run up

    Remove rotor to split crank case?

    amc49 11-23-2020, 08:23 AM Go to last post