• CB750.com is dedicated to the Honda CB750 SOHC and DOHC motorcycles and to their owners who love to ride, restore, and customize them.  All CB750 enthusiasts are welcome regardless of where you are from or whether you are into CB750 choppers, bobbers, cafe racers, drag bikes, or restorations.  Enjoy the site!
  • Stabler's Amen Savior CB750

    Check out Johnny's (Stabler) 1971 Amen Savior CB750 build! It turned out great! He bought the frame on Ebay in 2009 and had it delivered in early 2010. The project took about three years to complete. He started by getting a CB750K5 motor with the later '77-'78 carbs and a MAC exhaust. He had the handlebars custom made to his specifications out of stainless tubing. Stabler made a stainless steel bracket to mount the NOS (New Old Stock) Sears auxiliary lights and he also made the sissy bar from stainless round bar. The bike has a Harley Narrow Glide front end with a 21" wheel up front and an 18" wheel in the rear. The seat is an old C&G that Stabler reupholstered himself. The tank is an old '70s GME and the rear fender is a simple bobbed flat fender. The paint job was done by Mats Kroon.

    See the build from start to finish.

    Click to enlarge:

    This article was originally published in forum thread: My Amen Savior CB750 started by Stabler View original post
  • Recent Forum Posts


    I would guess you probably broke a oil ring while putting the cylinder on. Or you got a piece of trash inside that is binding up maybe in the timing

    1972 Engine Seized Post Top End Rebuild

    dirtdigger Yesterday, 08:29 PM Go to last post
    Medyo Bastos

    Sync carbs

    Sent from my iPhone using Tapatalk

    Grinding sound when in neutral

    Medyo Bastos Yesterday, 07:42 PM Go to last post

    So I'm currently working on a top end rebuild for a 1972 CB750. When I got the bike, the engine turned over easily, but as it hadn't been run in a while

    1972 Engine Seized Post Top End Rebuild

    gatorforge Yesterday, 06:06 PM Go to last post

    Yes. I would take the spark plugs out first and turn it over. I would then take a compression test if you have a compression tester. I think you can rent

    Where to start

    cttrail90 Yesterday, 12:02 PM Go to last post

    Have 78 CB750A with no spark. I tested the voltage going to the coil and only getting 8 or so volts. Should I be getting 12 volts?

    Voltage to coils

    cttrail90 Yesterday, 09:28 AM Go to last post

    These work:


    Sent from my SM-A520W using Tapatalk


    Skelee 07-14-2018, 11:45 AM Go to last post