• CB750.com is dedicated to the Honda CB750 SOHC and DOHC motorcycles and to their owners who love to ride, restore, and customize them.  All CB750 enthusiasts are welcome regardless of where you are from or whether you are into CB750 choppers, bobbers, cafe racers, drag bikes, or restorations.  Enjoy the site!
  • Stabler's Amen Savior CB750

    Check out Johnny's (Stabler) 1971 Amen Savior CB750 build! It turned out great! He bought the frame on Ebay in 2009 and had it delivered in early 2010. The project took about three years to complete. He started by getting a CB750K5 motor with the later '77-'78 carbs and a MAC exhaust. He had the handlebars custom made to his specifications out of stainless tubing. Stabler made a stainless steel bracket to mount the NOS (New Old Stock) Sears auxiliary lights and he also made the sissy bar from stainless round bar. The bike has a Harley Narrow Glide front end with a 21" wheel up front and an 18" wheel in the rear. The seat is an old C&G that Stabler reupholstered himself. The tank is an old '70s GME and the rear fender is a simple bobbed flat fender. The paint job was done by Mats Kroon.

    See the build from start to finish.

    Click to enlarge:

    This article was originally published in forum thread: My Amen Savior CB750 started by Stabler View original post
  • Recent Forum Posts


    The Kendas are mounted and wheels back on. That's about as far as the weather and my health could take her this week. Came down with a cold that knocked

    The Rocket, or pidjones winter of 18-19 rat bike project

    pidjones Today, 09:13 AM Go to last post

    The most of the CB750K models from 79-82 had spoke wheels, they should be a direct swap.

    What spoked wheels fit?

    grepper Yesterday, 03:36 PM Go to last post

    Thanks for all the info, and yes I will be especially careful putting it back together, Have read all the horror stories about the clutch pressure plate

    Looking for CLutch pressure plate

    ricerocket71 Yesterday, 12:04 PM Go to last post

    I'm with you shaube. I hate for my bike to scream when I'm just cruising. Did you ever change your final drive gear ratio? I'm going to change mine before

    Final drive gearing.

    docjones Yesterday, 09:46 AM Go to last post

    As it turns out the the crash bars / Engine Guards / Highway Bars that I purchased are made in Viet Nam and are made of Stainless Steel. The quality isn't

    Crash Bars from China

    docjones Yesterday, 09:17 AM Go to last post

    I am looking for air filter spring and side cover to air box. What is the condition of the carbs?

    Thank you


    2Wheels 01-17-2019, 04:08 PM Go to last post