• CB750.com is dedicated to the Honda CB750 SOHC and DOHC motorcycles and to their owners who love to ride, restore, and customize them.  All CB750 enthusiasts are welcome regardless of where you are from or whether you are into CB750 choppers, bobbers, cafe racers, drag bikes, or restorations.  Enjoy the site!
  • Stabler's Amen Savior CB750

    Check out Johnny's (Stabler) 1971 Amen Savior CB750 build! It turned out great! He bought the frame on Ebay in 2009 and had it delivered in early 2010. The project took about three years to complete. He started by getting a CB750K5 motor with the later '77-'78 carbs and a MAC exhaust. He had the handlebars custom made to his specifications out of stainless tubing. Stabler made a stainless steel bracket to mount the NOS (New Old Stock) Sears auxiliary lights and he also made the sissy bar from stainless round bar. The bike has a Harley Narrow Glide front end with a 21" wheel up front and an 18" wheel in the rear. The seat is an old C&G that Stabler reupholstered himself. The tank is an old '70s GME and the rear fender is a simple bobbed flat fender. The paint job was done by Mats Kroon.

    See the build from start to finish.

    Click to enlarge:

    This article was originally published in forum thread: My Amen Savior CB750 started by Stabler View original post
  • Recent Forum Posts



    Thanks. I'm probably just going to replace both at the same time. Mo money, mo money.................

    1979 CB750F not charging

    everready Today, 07:03 PM Go to last post

    Clear bulb, a clear lens cannot filter out the red.

    Watch the bulb LED configuration too, some make beautiful light as long as you are directly

    LED Brakelight

    amc49 Today, 06:32 PM Go to last post

    Makes plenty of sense, the most common way these fail, the rotor. The regulator supplies power to the field (rotor, through the brushes) to magnetize

    1979 CB750F not charging

    amc49 Today, 06:27 PM Go to last post

    I'm not 100% clear on what 'imperial' entails but if in thousandths then it is the same as what we call SAE (Society of Automotive Engineers set the standards

    Valve shims

    amc49 Today, 06:09 PM Go to last post

    Thanks Chris, do you measure & calculate clearances/shims in metricvor imperial?
    Cheers Windy

    Valve shims

    Windy Today, 04:35 PM Go to last post
    Chris in Dorset England

    David Silver Spares near Saxmunden not far from you

    Valve shims

    Chris in Dorset England Today, 03:25 PM Go to last post