• CB750.com is dedicated to the Honda CB750 SOHC and DOHC motorcycles and to their owners who love to ride, restore, and customize them.  All CB750 enthusiasts are welcome regardless of where you are from or whether you are into CB750 choppers, bobbers, cafe racers, drag bikes, or restorations.  Enjoy the site!
  • Stabler's Amen Savior CB750

    Check out Johnny's (Stabler) 1971 Amen Savior CB750 build! It turned out great! He bought the frame on Ebay in 2009 and had it delivered in early 2010. The project took about three years to complete. He started by getting a CB750K5 motor with the later '77-'78 carbs and a MAC exhaust. He had the handlebars custom made to his specifications out of stainless tubing. Stabler made a stainless steel bracket to mount the NOS (New Old Stock) Sears auxiliary lights and he also made the sissy bar from stainless round bar. The bike has a Harley Narrow Glide front end with a 21" wheel up front and an 18" wheel in the rear. The seat is an old C&G that Stabler reupholstered himself. The tank is an old '70s GME and the rear fender is a simple bobbed flat fender. The paint job was done by Mats Kroon.

    See the build from start to finish.

    Click to enlarge:

    This article was originally published in forum thread: My Amen Savior CB750 started by Stabler View original post
  • Recent Forum Posts


    Try using a heat gun to warm up the rubber boots.

    Sent from my iPhone using Tapatalk

    Carb assembly stuck in engine manifold!

    fg1972 Today, 08:56 PM Go to last post


    Looking for info from Honda CB750 sandcast experts out there.

    Does anyone know how many of the early sandcast

    1969 CB750 Throttle Cables

    hvills Today, 06:07 AM Go to last post

    Thanks for the reply. I investigated a bit more with a large square and level. It’s only the subframe that slightly twisted. It shouldn’t be too hard

    Rear wheel centering

    NatetheNoob Yesterday, 10:49 PM Go to last post

    There is absolutely no way to answer that, you are the only one that can. If you are not in line on the swingarm what you are considering doesn't even

    Rear wheel centering

    amc49 Yesterday, 08:44 PM Go to last post

    Enough mileage the carb manifolds have cooked hard as rock to crack in pieces when you finally get carbs off. Not unusual.

    Carb assembly stuck in engine manifold!

    amc49 Yesterday, 08:34 PM Go to last post

    Hi all, new guy Rob here. Writing about my '92 Nighthawk 750. I am in the process of removing the carb assembly and it will not budge from the engine.

    Carb assembly stuck in engine manifold!

    bertness72 Yesterday, 08:31 PM Go to last post